S1000 Firmware 1.2.11 Release Highlights

Audio Monitoring over IP

The S1000 Smart Controller now enables you to monitor and control Audio devices connected to the S1000 Smart Controller.
The SPG Audio Listen in Module (SD1-AUDIO4) and Audio Converter expansion card (SE1-AUDIOBUS) are required for the Microphone and Speakers to communicate with ARCO Platform.

When the Sip Call Center Service receives call a call from a User, it sends commands to ARCO requesting S1000 gateway to make a callback. When Sip Service receives the callback from the S1000 gateway, it looks for active incoming call and transfers the S1000 gateway’s call to the User.

Modbus over Serial/IP

The S1000 Smart Controller now enables support for Modbus device connection using RS485 and TCP/IP. The Controller can add a Modbus device and then allow mapping of analogue and digital inputs. This enables the support up to 8 analogue and 8 digital outputs on a Modbus device.

CRI Expansion Card

The SPG Card Reader Expansion card (SE1-CRI-PCB) provides an easy expansion for an S1000 Smart Controller, providing additional control of up to 2 doors. The board has built-in dual Wiegand reader support for In/Out readers on the door and has 2 relay outputs. There is also 2 additional digital or analogue inputs software configurable that can be used for Break glass and Door contact functions. Additionally, if the Wiegand inputs are not used, they can also be configured as Digital or Analog inputs for RTE or other general-purpose inputs.

Aperio Integration

The S1000 Smart Controller now enables the use of ASSA ABLOY Aperio devices. Multiple Aperio devices can communicate with one or more hubs using short-distance wireless communications. The hubs communicate with the S1000 Controller via RS485 Serial Data connection.

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published.